This page was printed from

Thermocutter features handle that never gets hot

February 1st, 2009 / By: / New Products

Problem: Hot knife cutters tend to be heavy, and the handle can get uncomfortably hot.

Solution: At only 11 1/2 ounces, the AZTC-20 electronic thermocutter from Abbeon Cal Inc. is less than half the weight of other cutters. The transformer found on other cutters has been replaced by high-tech electronics so the handle will never get hot, and cutter temperature is controlled from zero to 1,050 degrees with a flick of the thumb. A cutting foot accessory is also available.

SOURCE Abbeon Cal Inc.

Leave a Reply

Your email address will not be published. Required fields are marked *

Comments are moderated and will show up after being approved.